osc updated the gui dialog for spelling and accuracy

diff --git a/include/osc58-using-the-setup-dialog.html b/include/osc58-using-the-setup-dialog.html
index 89dacd3488981105631ce45c7b63f46bda311e03..c498b42b13c39c29155f7434de088b4cb532122b 100644 (file)
--- a/include/osc58-using-the-setup-dialog.html
+++ b/include/osc58-using-the-setup-dialog.html
@@ -43,12 +43,12 @@
 </p>
 <p>
   This drop down allows the choice of Auto or Manual outbound port
-  setting. The default Auto port mode, will send OSC messages back to
+  setting. The Auto port mode, will send OSC messages back to
   the port messages from that surface are received from. This setting
   allows two surfaces on the same IP to operate independently. However,
   there are a number of OSC control surfaces that do not monitor the
   same port they send from and in fact may change ports they send from
-  as well. Manual allows the outgoing port (the port the surface will
+  as well. Manual allows the outgoing port, the port the surface will
   receive on, to be manually set. In Manual port mode only one control
   surface per IP can work. Most phone or tablet OSC controllers like
   touchOSC or Control need Manual port mode. More than one controller