- All buttons act on release (not press), exceptions are mentioned below.
+ Buttons generlaly act on release (not press), with exception
+ of transport-control (since 6.0pre) and individual exceptions mentioned below.
Transport Buttons
Stop: Stops the transport. Press twice to return to
@@ -107,8 +112,10 @@
With exception of Click the seven modes are exclusive (radio buttons).
Channel: The Prev / Next
@@ -170,8 +177,10 @@
Shift Button
The two Shift buttons are identical, they're copied to provide
@@ -196,8 +205,10 @@
(Note: with the 1.01 firmware these buttons always act on press.)
Track: In Track-mode, the motorized faders display
@@ -257,8 +268,10 @@
Channel Strip
Touch-Sensitive Fader: The fader can be used to control
@@ -323,8 +336,10 @@
channel-strips.
Audio: View Audio Tracks only.
@@ -363,8 +378,10 @@
and pan automation modes respectively.
Latch: Currently not available in Ardour.
@@ -399,8 +416,10 @@
Miscellaneous
Solo Clear: Reset all solo controls in the
@@ -474,10 +493,10 @@ The above also applies to Ardour-derivatives Harrison-Mixbus and Mixbus 32C with
Mix Management Bus shows Mixbusses only, while FX spills Aux-busses.
- The Mixbus built-in EQ and Compressor are present on every track and bus and always available. They are displayed as special plugins on right-side in Select Plugin Mode.
+ The Mixbus built-in EQ and Compressor are present on every track and bus and always available. They are displayed as special plugins on right-side in Select Plugin Mode.
When editing those processors, the parameters follows track selection (for other plugins this is not possible since they may not be present).
- Fader mode Sends shows mixbus-assigns first (before any optional aux-sends). The master-bus-assign is available on the "S"olo button of the right-most strip.
+ Fader mode Sends shows mixbus-assigns first (before any optional aux-sends). The master-bus-assign is available on the "S"olo button of the right-most strip.