- Auxilliary sends are simple Auxiliary sends are simple processors in a bus or track channel strip. They tap the signal at a specific point in the signal flow (pre-fader, post-fader, before or after EQs and other plugins, etc.) @@ -11,14 +11,15 @@ Aux sends from several tracks are collectively sent to a bus in Ardour, to create a monitor mix for a musician, or to feed an effect unit. A bus used in this way is considered - an auxilliary bus or Aux bus even though it is the same as + an auxiliary bus or Aux bus even though it is the same as any other bus. The output of such a bus might be routed to separate hardware outputs (in the case of headphone or monitor wedge mixes), or returned to the main mix (in the case of an effect).
- Aux sends are not JACK ports, - External Sends should be used to send audio to Jack ports. External Sends can + Aux sends do not show up outside of Ardour either on the audio device + or as JACK ports, External Sends should + be used to send audio to the audio device or Jack ports. External Sends can send the tapped signal somewhere else directly, which is not usually possible on hardware mixers.
@@ -88,7 +89,7 @@ channel strip.Every send processor has a small horizontal fader that can be adjusted in the -usual way. It is not very big and so this can be a little unsatisfactory if you want +usual way. It is not very big and so this can be a little unsatisfactory if a very fine control over the send level is required.