A bit of styling for the 1-page version

[ardour-manual] / include / osc58-using-the-setup-dialog.html

diff --git a/include/osc58-using-the-setup-dialog.html b/include/osc58-using-the-setup-dialog.html
index 89dacd3488981105631ce45c7b63f46bda311e03..5c440d290520468dd5fa191e8d2f596312fc0ef2 100644 (file)
--- a/include/osc58-using-the-setup-dialog.html
+++ b/include/osc58-using-the-setup-dialog.html
@@ -32,7 +32,7 @@
 <p>
   This field is informational only. It shows where Ardour will receive
   OSC messages. The system Name and the Port are the most important parts.
-  Normally, Ardour will use 3819 as it's server port. However, if some
+  Normally, Ardour will use 3819 as its server port. However, if some
   other server is already using this port, Ardour will try to use the next
   port up and will keep trying up to 10 ports up.
 </p>
@@ -43,12 +43,12 @@
 </p>
 <p>
   This drop down allows the choice of Auto or Manual outbound port
-  setting. The default Auto port mode, will send OSC messages back to
+  setting. The Auto port mode, will send OSC messages back to
   the port messages from that surface are received from. This setting
   allows two surfaces on the same IP to operate independently. However,
   there are a number of OSC control surfaces that do not monitor the
   same port they send from and in fact may change ports they send from
-  as well. Manual allows the outgoing port (the port the surface will
+  as well. Manual allows the outgoing port, the port the surface will
   receive on, to be manually set. In Manual port mode only one control
   surface per IP can work. Most phone or tablet OSC controllers like
   touchOSC or Control need Manual port mode. More than one controller