</p>
<p>
This drop down allows the choice of Auto or Manual outbound port
- setting. The default Auto port mode, will send OSC messages back to
+ setting. The Auto port mode, will send OSC messages back to
the port messages from that surface are received from. This setting
allows two surfaces on the same IP to operate independently. However,
there are a number of OSC control surfaces that do not monitor the
same port they send from and in fact may change ports they send from
- as well. Manual allows the outgoing port (the port the surface will
+ as well. Manual allows the outgoing port, the port the surface will
receive on, to be manually set. In Manual port mode only one control
surface per IP can work. Most phone or tablet OSC controllers like
touchOSC or Control need Manual port mode. More than one controller