replaced img with Figure

[ardour-manual] / include / aux-sends.html

diff --git a/include/aux-sends.html b/include/aux-sends.html
index 3b8ca702391e7865bc22c3481320d09a5a35e23d..a7794ab94ed92ed236f66d886c24f82ac2f496f3 100644 (file)
--- a/include/aux-sends.html
+++ b/include/aux-sends.html
@@ -1,6 +1,6 @@
 
 <p>
-  <dfn>Auxilliary sends</dfn> are simple <a
+  <dfn>Auxiliary sends</dfn> are simple <a
   href="@@processor-box">processors</a> in a bus or
   track channel strip. They tap the signal at a specific point in the signal
   flow (pre-fader, post-fader, before or after EQs and other plugins, etc.)
@@ -11,7 +11,7 @@
   Aux sends from several tracks are collectively sent to a
   <dfn>bus</dfn> in Ardour, to create a monitor mix for a
   musician, or to feed an effect unit. A bus used in this way is considered
-  an auxilliary bus or <dfn>Aux bus</dfn> even though it is the same as
+  an auxiliary bus or <dfn>Aux bus</dfn> even though it is the same as
   any other bus. The output of such a bus might
   be routed to separate hardware outputs (in the case of headphone or monitor
   wedge mixes), or returned to the main mix (in the case of an effect).
@@ -88,7 +88,7 @@ channel strip.
 <h3>Using the Send Fader</h3>
 <p>
   Every send processor has a small horizontal fader that can be adjusted in the
-usual way. It is not very big and so this can be a little unsatisfactory if you want
+usual way. It is not very big and so this can be a little unsatisfactory if
 a very fine control over the send level is required.
 </p>
 <h3>Map Aux Sends To Main Faders</h3>