Add Clips in the Editor chapter

[ardour-manual] / include / aux-sends.html

diff --git a/include/aux-sends.html b/include/aux-sends.html
index 69b9b7a2f9ddcdbc1db2f52c5b0d46f2eed30f03..6b37c0b31f0d28118a3ab278b08e53ae3a725b7c 100644 (file)
--- a/include/aux-sends.html
+++ b/include/aux-sends.html
@@ -1,6 +1,6 @@
 
 <p>
-  <dfn>Auxilliary sends</dfn> are simple <a
+  <dfn>Auxiliary sends</dfn> are simple <a
   href="@@processor-box">processors</a> in a bus or
   track channel strip. They tap the signal at a specific point in the signal
   flow (pre-fader, post-fader, before or after EQs and other plugins, etc.)
@@ -11,14 +11,15 @@
   Aux sends from several tracks are collectively sent to a
   <dfn>bus</dfn> in Ardour, to create a monitor mix for a
   musician, or to feed an effect unit. A bus used in this way is considered
-  an auxilliary bus or <dfn>Aux bus</dfn> even though it is the same as
+  an auxiliary bus or <dfn>Aux bus</dfn> even though it is the same as
   any other bus. The output of such a bus might
   be routed to separate hardware outputs (in the case of headphone or monitor
   wedge mixes), or returned to the main mix (in the case of an effect).
 </p>
 <p>
-  Aux sends are not JACK ports, <a href="@@external-sends">
-  External Sends</a> should be used to send audio to Jack ports. External Sends can
+  Aux sends do not show up outside of Ardour either on the audio device
+  or as JACK ports, <a href="@@external-sends">External Sends</a> should
+  be used to send audio to the audio device or Jack ports. External Sends can
   send the tapped signal somewhere else directly, which is not usually
   possible on hardware mixers.
 </p>
@@ -88,18 +89,18 @@ channel strip.
 <h3>Using the Send Fader</h3>
 <p>
   Every send processor has a small horizontal fader that can be adjusted in the
-usual way. It is not very big and so this can be a little unsatisfactory if you
+usual way. It is not very big and so this can be a little unsatisfactory if
 a very fine control over the send level is required.
 </p>
 <h3>Map Aux Sends To Main Faders</h3>
 <p>
-  In Mixer mode, pressing the button marked <kbd class="menu">Aux</kbd> on a aux bus will
+  In Mixer mode, pressing the button marked <kbd class="menu">Show Sends</kbd> on a aux bus will
   alter the channel strip for every track or bus that feeds the aux bus. Many
   aspects of the strip will become insensitive and/or change their visual
   appearance. More importantly, the main fader of the affected channel strips
   will now control the send level and <strong>not</strong> the track gain.
   This gives a larger, more configurable control to alter the level. Clicking the
-  <kbd class="menu">Aux</kbd> button of the aux bus again reverts the
+  <kbd class="menu">Show Sends</kbd> button of the aux bus again reverts the
   channel strips to their normal use.
 </p>