Tidying doc about Cleaning up Sessions

[ardour-manual] / _manual / 14_signal-routing / 01_aux-sends.html

diff --git a/_manual/14_signal-routing/01_aux-sends.html b/_manual/14_signal-routing/01_aux-sends.html
index faa07bedd51e7226f30adad1512a80fd5f39e9f7..f2354f2b28761950be8d99292ad241c4093be352 100644 (file)
--- a/_manual/14_signal-routing/01_aux-sends.html
+++ b/_manual/14_signal-routing/01_aux-sends.html
@@ -20,13 +20,13 @@ title: Aux Sends
   />
   Since sends are JACK ports, it is also possible to send the tapped signal
   somewhere else directly, which is not usually possible on hardware mixers
-  (see <a href="external-sends/">External Sends</a>).
+  (see <a href="/signal-routing/external-sends/">External Sends</a>).
 </p>
   
 <p>
   It may be useful to 
-  <a href="/signal-routing/comparing-aux-sends-and-subgroups">compare and contrast</a> 
-  the use of aux sends with <a href="/signal-routing/subgrouping">subgrouping</a>.
+  <a href="/signal-routing/comparing-aux-sends-and-subgroups/">compare and contrast</a> 
+  the use of aux sends with <a href="/signal-routing/subgrouping/">subgrouping</a>.
 </p>
 
 <h2>Adding a new aux bus</h2>
@@ -50,7 +50,7 @@ title: Aux Sends
   the new aux send can be placed before or after the fader in the channel strip. 
   <dfn>Post-fader</dfn> aux sends are typically used when using an aux for shared signal 
   processing (FX), so that the amount of effect is always proportional to
-  the main mix fader. <dfn>Pre-fader sends</dfn> ensure that the level sent to the bus 
+  the main mix fader. <dfn>Pre-fader</dfn> sends ensure that the level sent to the bus 
   is controlled <em>only</em> by the send, not the main fader &mdash; this is typical 
   when constructing headphone and monitor wedge mixes. 
 </p>
@@ -69,7 +69,7 @@ title: Aux Sends
 <h2>Altering Send Levels</h2>
 <p>
   You can alter the amount of the signal received by a send that it delivers to the bus 
-  it connects to. There are two approaches to this:
+  it connects to. There are three approaches to this:
 </p>
 <h3>Use the Send Fader</h3>
 <p>
@@ -92,7 +92,7 @@ title: Aux Sends
   appearance. More importantly, the main fader of the affected channel strips 
   will now control the send level and <strong>not</strong> the track gain. 
   This gives a larger, more configurable control to alter the level. Click the 
-  <kbd class=="menu">Aux Sends</kbd> button of the aux bus again to revert the 
+  <kbd class="menu">Aux Sends</kbd> button of the aux bus again to revert the 
   channel strips to their normal use.
 </p>
 <h2>Disabling Sends</h2>