the new aux send can be placed before or after the fader in the channel strip.
<dfn>Post-fader</dfn> aux sends are typically used when using an aux for shared signal
processing (FX), so that the amount of effect is always proportional to
- the main mix fader. <dfn>Pre-fader sends</dfn> ensure that the level sent to the bus
+ the main mix fader. <dfn>Pre-fader</dfn> sends ensure that the level sent to the bus
is controlled <em>only</em> by the send, not the main fader — this is typical
when constructing headphone and monitor wedge mixes.
</p>
<h2>Altering Send Levels</h2>
<p>
You can alter the amount of the signal received by a send that it delivers to the bus
- it connects to. There are two approaches to this:
+ it connects to. There are three approaches to this:
</p>
<h3>Use the Send Fader</h3>
<p>
appearance. More importantly, the main fader of the affected channel strips
will now control the send level and <strong>not</strong> the track gain.
This gives a larger, more configurable control to alter the level. Click the
- <kbd class==menu">Aux Sends</kbd> button of the aux bus again to revert the
+ <kbd class="menu">Aux Sends</kbd> button of the aux bus again to revert the
channel strips to their normal use.
</p>
<h2>Disabling Sends</h2>