The default mono panner distributes 1 input to 2 outputs. Its behaviour is controlled by a single parameter, the position. By default, the panner is centered.

Mono Panner User Interface

The mono panner looks a quite similar to the stereo panner interface. The difference is that the L/R labels in the lower half of the mono panner do not move because there is no "width" to control.

Using the mouse

To change the position smoothly, press the right button and drag anywhere within the panner. Note: you do not need to grab the position indicator in order to drag

Reset to defaults

Click right

Change to a "hard left"

Double click right in the left side of the panner

Change to a "hard right"

Double click right in the right side of the panner

Set the position to center

Double Click right in the middle of the panner

Keyboard bindings

When the pointer is within a mono panner user interface, the following keybindings are available to operate on that panner:

← / ←

move position 1° / 5° to the left

→ / →

move position 1° / 5° to the right

0

reset position to center

Using the scroll wheel/touch scroll

When the pointer is within a mono panner user interface, the scroll wheel may be used as follows:

⇑ or ⇐

move position to the left by 1°

⇑ or ⇐

move position to the left by 5°

⇓ or ⇒

move position to the right by 1°

⇓ or ⇒

move position to the right by 5°