2 <h2>Adding new notes</h2>
4 In general, you will probably do most MIDI editing with the mouse in object
5 mode. This allows you to select notes, copy, move or delete them and alter
6 their properties (see below). But at some point, you're going to want to
7 <em>add</em> notes to a MIDI region using the mouse, and if they are to be
8 anything other than a fixed length, this means dragging with the mouse.
9 Since this would normally be a selection operation if the mouse is in object
10 mode, there needs to be some way for you to tell Ardour that you are trying
11 to <dfn>draw</dfn> new notes within a MIDI region. Ardour provides two ways
12 do this. One is to leave the mouse in object mode and
13 <kbd class="mouse mod1">Left</kbd>-drag. The other, useful if you plan to
14 enter a lot of notes for a while, is to switch the mouse into
15 <kbd class="menu">Draw Notes</kbd> mode, which will now interpret any drags
16 and clicks as requests to add a new note. For obvious reasons, you cannot
17 use Draw Notes mode while using region-level editing.
20 <p>So, to summarize:</p>
21 <dl class="wide-table">
22 <dt>Selecting, moving, copying, trimming, deleting <em>regions</em></dt>
24 leave <kbd class="menu">Note Level Editing</kbd> disabled, use object,
25 range or other mouse modes
27 <dt>Selecting, moving, copying trimming, deleting <em>notes</em></dt>
28 <dd>enable <kbd class="menu">Note Level Editing</kbd>and use mouse object mode</dd>
29 <dt>Adding new notes</dt>
31 enable "Note Level Editing" and then either
33 <li>use mouse object mode and <kbd class="mouse mod1">Left</kbd>-drag,
35 <li>use mouse draw mode.</li>
41 <a href="/working-with-midi/step-entry/">a step entry editor</a>
42 allowing you to enter notes from a virtual keyboard and lots more besides.