3 title: Working With Extenders
4 menu_title: Working With Extenders
8 There are currently 5 devices preconfigured to work with extenders.
9 Two of them are for one master and one extender with the master on the
10 right side or master on the left side. There are three presets for a
11 master and two extenders with the master on the left, in the center
12 and on the right. While these files will work for many uses there may
13 be cases where a custom device profile makes more sense.
14 The best way is to start with the *.device file that matches your
15 master device and copy it
16 to a new name such as xt+mc.device and then edit that file. It is best to
17 name the file with the order the devices are expected to be used in as
18 the position of the master device is specified in this file.
21 The three lines of interest are:
24 <Name value="Device name"/>
25 <Extenders value="0"/>
26 <MasterPosition value="0"/>
29 Add any lines that are not present.
32 The <code>Name</code> value should be a unique name so it is obvious
33 in the list of devices.
36 The <code>Extenders</code>
37 value is the number of extenders used and should not include the master in
41 When an <code>Extenders</code> value of greater than 0 is used, extra midi
42 ports will appear for the extenders to be connected to. The MIDI ports
43 for the controllers will be named <code>mackie control #1</code>,
44 <code>mackie control #2</code> and up. The numbers will go from left to
45 right. That is, from lowest number channel to highest.
48 The <code>MasterPosition</code> value is the port number the master unit
49 (with the master fader) is connected to. So if there are three surfaces,
50 <code><MasterPosition value="1"/></code> will expect the master on
51 the left, <code><MasterPosition value="2"/></code> would be master
52 in the middle and <code><MasterPosition value="3"/></code> would be
53 master on the right. So the position matches the port name.
56 The default value of <code><MasterPosition value="0"/></code> has
57 the same effect as <code><MasterPosition value="1"/></code>.
60 If the <code>MasterPosition</code> value does not properly match the
61 physcal position and MIDI port, the master fader and global controls will
62 not work. The master unit will act like an extender.